首页 > 技术文章 > Raspberry Pi3 ~ 配置网络

einstein-2014731 2016-04-27 16:12 原文

Rpi3 有两个网卡 一个无线wlan 一个有线 eth0

无线的只需要在右上角的那个配置里面添加就行

有线的需要设置下静态IP、dns、等

在raspbain图形化界面里面 设置 Network Perferences

取消勾选 Auto matically configure empty options

然后配置

IP Address 192.168.3.169

Router   192.168.3.1

DNS Servers  61.153.177.196

重启下Rpi 3  即可

 

使用命令配置  这里参考的是 这篇博文

1、配置mac地址

sudo ifconfig eth0 down hw ether xx:xx:xx:xx:xx:xx  
sudo ifconfig eth0 up


将上面两行代码复制进/etc/rc.local即可开机自动更改。

单独运行上面两行即可修改mac地址

 

2、设置IP与静态网关等

备份/etc/network/interfaces文件,并修改如下:

1)注释掉

iface eth0 inet dhcp 

2)添加以下几行

    # The loopback interface  
     auto lo  
     iface lo inet loopback  
     auto eth0  
     iface eth0 inet static  
     #your static IP  
     address 192.168.3.169   
     #your gateway IP  
     gateway 192.168.3.1  
     netmask 255.255.255.0  
     #your network address "family"  
     network 192.168.3.0  

其中network由IP决定,其最终结果为IP地址最后一位改为0

 

4)配置DNS服务器

在:/etc/resolv.conf中添加一条

nameserver  61.153.177.196


结束

若提示以下错误:

pi@raspberrypi:~$ ping 10.10.10.34  
connect: Network is unreachable

解决方法 可以在/etc/rc.local中在ifconfig eth0 up后面加

/etc/init.d/networking restart &

 

推荐阅读